Spread the 1x6x4 matches (a) bar, cut the edges and give it the type of car body, as shown in the photo: b — type of body from below; B — type of housing on the side.
Of the single matches of a length of 5 mm, create an end support for the roof of the car body.
Disappel in half 5 matches and pass them away from all sides. Start the resulting elements on a 10 × 25 mm paper strip, as shown in the photo.
From the spread in half the matches, make it up and stick to the body:
a — front and rear bumpers;
b — 2 elements ending the silhouette of the roof of the body.
From the spread in half the matches, make 4 arcs — the wings of the car (s). Their inner diameter is 10 mm. Stick made of wings on both sides of the car. From the spreading in half the matches, make and glue another 2 racks that support the roof of the car.
Machine of matches
From the spreads off in half, make:
a — 4 wedge-shaped arcs;
6-4 headlights with a diameter of 2 matches.
Enclose the elements made to the car body, as shown in the photo (A — Rear view, b — front view).
From single matches, glue: a — 4 wheels with a diameter of 2 matches; 6-4 axis diameter 1 match. Stick these details, as shown in the photo, and a few more details from the loose matches that the car’s silhouette will complete.
From spreading in half the matches, make and stick to the car:
a — 2 license plates;
b — 2 windshield holder (1/4 matches);
In — elements that end the equipment and the silhouette of the car.
Waiting for your interesting comments!
subscribe to the channel
And if you liked the article put your finger up!